The Machine came with little more than a single sheet and a CD full of Chinese versions of Mach3 and drivers for that. See Unboxing and setup for what else was in the device. The eBay auction also had a link to a MS Word document, which importantly had some of the pin connections so mach3 could be configured. I could cross ref this with the grbl connections to create a wiring plan for attaching it to my machine.

I flashed grbl onto an Arduino Uno R3 compatible board, using the hex file and the recommended windows file to upload this. I was able to use putty to talk to grbl and get responses from it.

I wired this into the parallel connector at the back of the control box, and started up the machine. Grbl resets when the machine is powered on - however, putty is still connected - this may mean some power related fluctation - I had also connected the Arduino to what I think was a ground on that port too - for the signals to make sense - they needed a common ground.

Arduino PinParallel port CnC Pin
A0Stop/Emergency reset 10
2Step Pulse X 2
3Step Pulse Y 4
4Step Pulse Z 6
5Step Dir X 3
6Step Dir Y 5
7Step Dir Z 7
GroundGround 18-25

I then proceeded to check the grbl settings - and was able to leave them at the defaults - they looked close to the mach3 settings in the screenshots from the manual.

I then issued my first attempt at a gCode command G00 X 50 which I think should make the X axis move from where it is now (an assumed zero/home point).

Nothing happened on the router - it stayed motionless. I knew from unboxing it that the stepper controllers were talking to the steppers, and I had been able to power up the spindle. I was able to use the ? command in grbl to see that it was trying to move.

I’ve am both awaiting a tiny mini-itx based pc to try with, and going to teardown/diagnose the controller to understand what is in it - and see what I may be doing wrong.

Thoughts - the reset may mean I had the wrong pin as ground - not a ground. Perhaps I have managed to offset or reverse stuff?

Other places to find us